Beckhoff CX9000 Instrukcja Użytkownika Pobierz pdf (Strona 51)

Appendix

Embedded PC 49

2. Prepare Image-Server (once)

Provide the image server on the host PC, the components are:

• Two batchfiles "CxImgSrv_HMI.bat" and "CxImgSrv_LF.bat"

Note that the CX9000 is shipped with different hardware environment (e.g. more or less flash memory).

• Folder "\Tools" contains the image server itself: CxImageSrv.exe

• Folder "\Images" contains the HMI and LF subfolders with the required file "Boot.bin"

If you receive a new NK.BIN file, just rename it to "Boot.bin" and provide it in the correct subfolder

3. Prepare CX9000

Prepare the "Boot-Strap Mode" on CX9000. There are two ways to set the CX9000 into "Boot-Strap Mode":

• set a DIP-switch on CX9000

• start a program, to set the CX9000 into"Boot-Strap Mode".

Prepare the CX9000 to start in "boot-strap" mode.

1. Power down the CX9000

2. Open the battery compartment (located between two ethernet ports)

It can be opened with the aid of a screwdriver (proceed carefully in order to avoid damage).

3. Find the dip switches 1,2,3,4 and set switch 3 from OFF to ON

Alternative the administrator can start a tool on the CX-Systems to set the CX9000 into "Boot-Strap Mode". First the

program must be downloaded from the BECKHOFF FTP-Server. If the CX9000 has no USB the tool can be

transferred via ftp onto the system. Use CERHOST-Tools to control the CX9000 remote via Ethernet. Activate the

FTP server on the CX, if not it is disabled. The necessary configuration is shown below:

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 60 61

Brak uwag

Beckhoff CX9000 Instrukcja Użytkownika Strona 51